Create an Enroll/Delete Card
To create an enroll card or delete card, click Device, select the reader you wish to attach the cards to, then select Command Card from the horizontal tab menu.
Under this tab, click on the drop menu beside Command Type, specify either ‘Enroll Card’ or ‘Delete Card’, and then click Read Card.
The reader will prompt you to place a card – either with a flashing yellow LED light or an on-screen message. While the reader is looking for input, place your card to the device until the Card ID numbers fill out.
Click Apply and the Enroll Card will be added.
Enrolling a New User
To enroll a user with the enroll card, present the Enroll Card to the reader. Once the reader reacts, it will prompt the new user to:
- Scan the new card (if using card + fingerprint)
- Place a finger
- Place the same finger a second time
In between each step the reader will output a positive or negative response – ex: a green LED light for success, and a red light for failure. If the enrollment process fails (flashes red), ensure your operation mode is set correctly and retry the process above.